Model No.: Hits: 76
Product name | Pinch Valve with pneumatic actuator | |
Work principle | The external air drives the cylinder to squeeze the inner sleeve to open or close | |
Size | DN25-DN1000 | |
Body Material | Ductile Iron/Aluminum Alloy/Carbon Steel | |
Rubber sleeve technology | Imported top hand-made technology | |
Sleeve material | High wear resistant red rubber/ Pure gum rubber /Neoprene /NBR/EPDM, etc | |
Protective coating | Bias-ply, fabric-reinforced | |
Pressure/Temperature | 0.6Mpa/1.0Mpa/1.6Mpa/ -35℃~+130℃ | |
Flange ends | PN10/16, ANSI 150LB, etc | |
Medium | Sewage, pulp, acid and alkali medium, dry powder, slurry and solids handling etc. | |
Actuator | Double acting or Single acting, accessories are available | |
Advantages | 1.No pressure loss, non-blocking, zero leakage, impact resistant 2.Full face-to-face integral elastomer molded flange 3.Manufactured to high standards 4.Superior service life 5.Sleeves available in a wide variety of elastomers 6.Custom sizes available 7.Bare body construction:The dynamic situation of the sleeve can be observed directly on the spot 8.With bias-ply, fabric-reinforced coating to protect the rubber sleeve, the sleeve is high abrasion resistant, corrosion resistant, tear resistant and fatigue resistant. 9.The sleeves are the only wetted part of the valve, eliminating the need for valve bodies made of expensive metal alloys. Because the sleeves are the only wetted part, they are the only replacement part needed in pinch valves, thus can save a lot of cost. |