Manual Pinch Valve Sleeve Type | JONLOO |Pinch Valve Supplier

Manual Pinch Valve Sleeve Type

Key Specifications / Features

Model No.: Hits: 70

China pinch valve manufacturer JONLOO supplies manual pinch valve sleeve type.
Request a quote

Detail Information

Product name  Manual Pinch Valve  
Work principle  Using the hand wheel to squeeze the inner sleeve to open or close  
Size DN25-DN1000  
Body Material  Ductile Iron/Aluminum Alloy/Carbon Steel/Stainless Steel  
Rubber sleeve technology Imported top hand-made technology  
Sleeve material High wear resistant red rubber/ Pure gum rubber /Neoprene /NBR/EPDM, etc  
Protective coating Bias-ply, fabric-reinforced  
Pressure/Temperature 0.6Mpa/1.0Mpa/1.6Mpa/-35℃~+130℃  
Flange ends PN10/16, ANSI 150LB, etc  
Medium Sewage, pulp, acid and alkali medium, dry powder, slurry and solids handling etc.  
Operator Handwheel  
Advantages 1.No pressure loss, non-blocking, zero leakage, impact resistant
2.Full face-to-face integral elastomer molded flange
3.Manufactured to high standards
4.Superior service life
5.Sleeves available in a wide variety of elastomers
6.Custom sizes available
7.Bare body construction:The dynamic situation of the sleeve can be observed directly on the spot
8.With bias-ply, fabric-reinforced coating to protect the rubber sleeve, the sleeve is high abrasion resistant, corrosion resistant, tear resistant and fatigue resistant.
9.The sleeves are the only wetted part of the valve, eliminating the need for valve bodies made of expensive metal alloys. Because the sleeves are the only wetted part, they are the only replacement part needed in pinch valves, thus can save a lot of cost.
 
 

Comment Form

Nickname*:
E-mail*:
Rate*:
Comments*:

Similar Products